Metrohm viva 1.1 (ProLab) - Manual (Page 696)

5.6 Evaluation subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
684 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
RSD of the calibration factor DT
Number of decimal places for the relative standard deviation of the cali-
bration factor DT (%).
This result exists solely for the calibration method = DT and the sample
type = Standard.
Input range 0 - 6
Default value 1
Effective addition volume of the sample solution for the evaluation ratio
Number of decimal places and prefix selection for the effective addition
volume of the sample solution for the evaluation ratio (L).
This result exists only for the calibration method DT and the sample type =
Sample.
Input range 0 - 6
Default value 2
Selection # | m | µ | n | p
Default value #
RSD of the effective addition volume of the sample solution for the evaluation ratio
Number of decimal places for the relative standard deviation of the effec-
tive addition volume of the sample solution for the evaluation ratio (%).
This result exists only for the calibration method DT and the sample type =
Sample.
Input range 0 - 6
Default value 1
[Basic setting]
Restore default values for the number of decimal places and the prefix.
5.6.6.5 Results - User-defined results
Tab: Method ▶ Evaluation ▶ Results ▶ User-defined results
Table
Additional user-defined results can be defined in this table which are auto-
matically included in the calculation. The main properties of a highlighted
result are displayed in the right-hand part of the tab. The results are calcu-
lated in the order in which they appear in the table. They can be moved
with the arrow key in order to change the sequence in which they appear.
The table cannot be edited directly and is comprised of the following col-
umns: