Metrohm viva 1.1 (ProLab) - Manual (Page 533)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 521
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Measuring parameters tab will be
used.
Stirrer
This section is displayed only when Device type = 089 Photometer.
Stirrer
Selection of the stirrer.
Selection 1 | off
Default value 1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate.
Input range 0 - 15
Default value 3
Switch off automatically
on | off (Default value: on)
If this check box is activated, the stirrer will be switched off automatically
when the command has finished.
5.5.2.7.4.3 MEAS Opt - Measuring parameters
Tab: Method ▶ MEAS Opt ▶ Properties... ▶ MEAS Opt - 'Command name' ▶ Mea-
suring parameters
Command name
Name of the command.
Entry 25 characters
The parameters for the measuring procedure can be defined on this tab.
Measuring parameters for the Avantes spectrometer
Wavelength
Wavelength at which the measured quantity (absorbance) is recorded.
Input range 100.0 - 2,000.0 nm
Default value 400.0 nm