Metrohm viva 1.1 (ProLab) - Manual (Page 361)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 349
For CAL Spec
Selection
Wavelength [nm] | Intensity [Counts] | Satura-
ted pixels
Default value Wavelength [nm]
For MEAS TMF
Selection
Time [s] | Measured value [mAU] | Transmis-
sion [%] | Temperature [°C] | d
ε/dt [mAU/min]
Default value Time [s]
Label
Freely definable axis label for the x axis. If auto is selected, then the desig-
nation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto
Scaling
Start value
Initial value for scaling the x axis.
Editable only when autoscaling is disabled.
Input range
-1.00E+12 - +1.00E+12
Default value -1.00E+12
End value
End value for scaling the x axis.
Editable only when autoscaling is disabled.
Input range
-1.00E+12 - +1.00E+12
Default value +1.00E+12
4.6.2.3.2 Curve properties measuring commands - y1 axis
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ y1 Axis
Parameters for the graphical display of the curves on the y1 axis (left-hand
y axis).
Quantity
Selection of the quantity to be shown on the y1 axis.