Metrohm viva 1.1 (ProLab) - Manual (Page 589)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 577
Parameters
The parameters for the START command are set on the following three
tabs:
￭ General
General settings for the method run.
￭ Application note
Possibility of creating an application note to be displayed at the start of
the determination.
￭ Sample data variables
Specification of sample data variables that are to be available for the
method.
Command variables
No command variables are generated in the method run by the START
command.
Sample data variables
The following sample data variables are defined in the START command
and can be used in formulas under the designation 'SD.Variable
name.Variable identification':
Identification Description
VAL Variable value (optional, i.e. 'SD.Factor'
= 'SD.Factor.VAL') (Text, Number or
Date/Time)
OVF Exceeding limits for sample data variables
of the Number type: 1 = limit
exceeded, 0 = limit not exceeded
In the following lines you will find the sample data variables (sample
data) present in the default settings which appear in the Run sub-
window and which can be edited and deleted in the START command
of the corresponding method.
ID1.VAL Value of ID1 (Text, Number or Date/
Time)
ID1.OVF Exceeding limit for 'ID1' (Number or
Date/Time)
ID2.VAL Value of ID2 (Text, Number or Date/
Time)