Metrohm viva 1.1 (ProLab) - Manual (Page 150)

3.6 Run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
138 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
￭ Processing a series start track
The Series start track is started at the beginning of the first determi-
nation of a series. If you click on [Stop] while this track is running,
then the Exit track is started; if an error occurs, the Error track will
be started.
￭ Main track processing
After the start of the Main track the status changes to BUSY. The
commands of the main track and of the tracks requested by it are pro-
cessed in sequence. If the main track requests tracks that are not free,
it will wait until these tracks can be started.
￭ Stopping and continuing a run
An ongoing determination can be interrupted with [Hold] and
resumed with [Cont] at any time. In this case, all active tracks are stop-
ped and resumed together.
￭ Stopping and continuing a series
An ongoing series can be interrupted at any time with [Pause]. In this
case, the ongoing determination of the sample series will still be car-
ried out to completion but no new determination will be started. The
next determination of the interrupted sample series is started with
[Cont].
￭ Canceling a run
An ongoing determination can be canceled at any time with [Stop].
Afterwards, the Exit track (if present) is run through and the determi-
nation is stopped.
￭ Stop by error
If an error that causes the determination to be interrupted occurs in an
ongoing determination, the Error track (if present) is run through and
the determination is stopped.
￭ Processing exit track
If the main track and all tracks requested by it are ended, then the Exit
track (if present) is run through and the determination is ended.
￭ Processing series end track
The Series end track is processed at the end of the last determina-
tion of a series. If you click on [Stop] while this track is running, then
the determination is ended; if an error occurs, the Error track will be
started.
3.6.4.8 Working sample table
3.6.4.8.1 Loading a new sample table
Menu item: Workplace ▶ Run ▶ Determination series ▶ [Sample table] ▶ New
A new, empty sample table is loaded as working sample table with the
[Sample table]
▶ New menu item on the Determination series tab,
i.e. all existing sample table lines will be deleted.