Metrohm viva 1.1 (ProLab) - Manual (Page 867)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 855
Input range 3 - 20 °/s
Default value 20 °/s
[Rack data]
Opens the Rack data dialog window (see Chapter 6.12.3, page 834), in
which the data of the attached rack can be viewed and edited.
[Initialize rack]
Initializes the attached rack. This resets the rack, the lift and the robotic
arm, reads out the rack code and transfers the corresponding rack data to
the Sample Processor.
7.3.5 Properties - Starting position
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Initializing position
On the Initializing position tab, a position can be defined which is auto-
matically approached when the device is initialized.
Move to initial position
on | off (Default value: off)
If this check box is activated, the position defined here is approached
when the device is initialized.
Tower
Selection of the tower on the sample changer for moving to the required
position.
Only editable for Move to initial position = on and if the corresponding
sample changer has two towers, otherwise inactive.
Selection 1 | 2
Default value 1
Move
Selection of the target position which is to be approached:
Only editable for Move to initial position = on, otherwise inactive.
Selection Rack position | Special beaker | External posi-
tion
Default value Rack position
Rack position
Predefined position on the rack. The lift is lowered to the work position
defined for that position.
Special beaker
Special position on the rack defined in the rack properties. The lift is
lowered to the work position defined for that position.