Metrohm viva 1.1 (ProLab) - Manual (Page 585)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 573
Angle
Angle that is to be traveled.
Only visible for a stepping motor of the Type = Rotary drive.
Input range -214783647 - 214783647 °
Default value 0 °
NOTE
The direction of travel of the stepping motor depends on the algebraic
sign of the value for Distance or Angle:
￭
≥ 0: Travel in positive direction.
￭
< 0: Travel in negative direction.
Start delay
Waiting time in seconds or minutes until the triggered action is started.
Input range 0 - 999,999
Default value 0
Selection s | min
Default value s
Timeout
Time in seconds or minutes during which the action must have been run
through completely. If this does not take place after the expiration of the
maximum waiting time, then the stepping motor will be set to the
ERROR status.
Input range 0 - 999,999
Default value 10
Selection s | min
Default value s
End delay
Waiting time after the maximum waiting time has expired.
Input range 0 - 999,999
Default value 0
Selection s | min
Default value s