Metrohm viva 1.1 (ProLab) - Manual (Page 571)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 559
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Device type field can no longer be edited
and the instrument type belonging to the instrument is displayed.
If the not defined option is selected in the Device name field, all instru-
ment types or groups with which the command can be executed can be
selected, regardless of the instruments present in the device table.
Selection IO Controller | Stepping Motor Controller
Default value IO Controller
5.5.2.8.3.3 DIGITAL IN - Stop criteria
Tab: Method ▶ DIGITAL IN ▶ Properties... ▶ DIGITAL IN - 'Command
name' ▶ Stop criteria
Command name
Name of the command.
Entry 25 characters
Stop criteria
Definition of possible stop criteria. The stop criterion that is reached first
leads to the cancellation of the command.
Maximum run time
on | off (Default value: off)
Check box for activation/deactivation of the stop criterion Maximum run
time. The command is canceled when the maximum run time has been
reached.
Input range 0 - 9,999.9
Default value 0
Selection min | s
Default value min