7 stepping motor, 1 stepping motor - overview, Stepping motor – Metrohm viva 1.1 (ProLab) User Manual
Page 581
■■■■■■■■■■■■■■■■■■■■■■
5 Method
viva 1.1 (for process analysis)
■■■■■■■■
569
This parameter is not displayed when Controller type = Direct control-
ler.
Action
Selection of the controller action.
Selection
Switch on | Switch off | Duration
Default value
Switch on
Switch on
Activation of the regulation.
Switch off
Deactivation of the regulation.
Duration
Activation of the regulation during a defined period.
Duration
Time period during which controlling is to take place.
Input range
0.0 - 9,999.9
Default value
10.0
Selection
min | s
Default value
s
5.5.2.8.7
STEPPING MOTOR
5.5.2.8.7.1
STEPPING MOTOR - Overview
Dialog window: Method
▶ STEPPING MOTOR ▶ Properties... ▶ STEPPING MOTOR
- 'Command name'
Instruments
This command can be executed with the Stepping Motor Controller.
Appearance
The command has the following appearance:
Mode of operation
Time-controlled actuation can be used with stepping motors.
Parameters
The parameters for the STEPPING MOTOR command are set on the fol-
lowing tabs:
■