Metrohm viva 1.1 (ProLab) User Manual
Page 545
■■■■■■■■■■■■■■■■■■■■■■
5 Method
viva 1.1 (for process analysis)
■■■■■■■■
533
Selection
'Name of the colorimetric sensor' | empty or
'first list entry'
Default value
empty or 'first list entry'
Temperature measurement
Type of temperature measurement.
Displayed only when Device type = 089 Photometer.
Selection
continuous | off
Default value
continuous
continuous
A temperature sensor must be connected. The temperature will then
be measured continuously.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Measuring parameters tab will be
used.
Stirrer
This section is displayed only when Device type = 089 Photometer.
Stirrer
Selection of the stirrer.
Selection
1 | off
Default value
1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate.
Input range
0 - 15
Default value
3
Switch off automatically
on | off (Default value: on)
If this check box is activated, the stirrer will be switched off automatically
when the command has finished.