Metrohm viva 1.1 (ProLab) - Manual (Page 493)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 481
5.5.2.5.3 CAL LOOP Opt
5.5.2.5.3.1 CAL LOOP Opt - Overview
Dialog window: Method ▶ CAL LOOP Opt ▶ Properties... ▶ CAL LOOP Opt - 'Com-
mand name'
General
The two commands CAL LOOP Opt and CAL MEAS Opt are available
for the calibration of colorimetric sensors. The quantity and type of
the standard solutions that can be measured with the CAL MEAS Opt
command are defined in the CAL LOOP loop command. Each time the
loop is executed, the validity of the concentration measurement is
checked, and at the end the calibration data for the colorimetric sensor is
calculated.
The basic structure of a calibration method looks as follows:
Appearance
The command has the following appearance:
Parameters
The parameters for the CAL LOOP Opt command are configured in the
following dialog window:
￭ CAL LOOP Opt - Properties