Metrohm viva 1.1 (ProLab) - Manual (Page 584)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
572 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
[Delete]
Deletes the selected line.
5.5.2.8.7.4 STEPPING MOTOR - Stepping motor#
Dialog: Method ▶ STEPPING MOTOR ▶ Properties... ▶ STEPPING MOTOR - 'Com-
mand name' ▶ Stepping motor ▶ [Properties] ▶ STEPPING MOTOR - Stepping
motor #
Port description
Selection of the stepping motor. The stepping motors of the selected
instrument are available. No port can be selected if not defined is
selected in the Device name field.
Type
Shows the stepping motor type.
Function
Action
Action which the stepping motor is to perform.
Selection 'empty' | Reference position | Relative posi-
tion | Absolute position | End position | Reset
Default value 'empty'
Reference position
Move to reference position of stepping motor.
Relative position
Go to a relative position; in this case, the stepping motor moves by the
value defined by Distance/Angle in relation to the current position.
Absolute position
Move to an absolute position; in this case, the stepping motor moves
to the value defined by Distance/Angle.
End position
Move to final position of the stepping motor.
Reset
The terminal to which the motor is connected is reset. In this process,
the LEDs of the terminal will flash briefly, afterwards it may be neces-
sary to reference again.
Distance
Distance that is to be moved.
Only visible for a stepping motor of the Type = Linear drive.
Input range -214783647 - 214783647 mm
Default value 0 mm