Metrohm viva 1.1 (ProLab) - Manual (Page 573)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 561
￭ Analog outputs
Command variables
The following command variables are generated by the ANALOG OUT
command in the method run and can be used in formulas under the des-
ignation 'Command name.Port name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
DEF Default value which is defined in the configuration
for an IO port.
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
not valid (variable not available) = Command
has not yet been started
UNI Mapping unit which is defined for an IO port in the
configuration
[VAL] Value of the command variables (optional, i.e. 'Com-
mand name.Portname' = 'Command
name.Portname.VAL'). The value returned corre-
sponds to the status of the IO port after the com-
mand is exited.
5.5.2.8.4.2 ANALOG OUT - General
Tab: Method ▶ ANALOG OUT ▶ Properties... ▶ ANALOG OUT - 'Command
name' ▶ General
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined