Metrohm viva 1.1 (ProLab) - Manual (Page 582)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
570 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
￭ Stepping motors
Command variables
The following command variables are generated by the STEPPING
MOTOR command in the method run and can be used in formulas under
the designation 'Command name.Port name.Variable identifica-
tion':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
not valid (variable not available) = Command
has not yet been started
5.5.2.8.7.2 STEPPING MOTOR - General
Tab: Method ▶ STEPPING MOTOR ▶ Properties... ▶ STEPPING MOTOR - 'Com-
mand name' ▶ General
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.