Metrohm viva 1.1 (ProLab) - Manual (Page 877)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 865
Work position [mm]
Work position for external position.
[Edit]
Opens the External position # dialog window (see Chapter 7.3.9, page
860), in which the parameters for the external position selected from the
table can be edited.
7.4.4 Properties - Rack
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Rack
The Rack tab shows the rack-specific data of the attached rack.
Rack name
Shows the name of the rack attached. If no rack is attached, then "-----" is
shown.
Rack code
Shows the rack code of the rack attached. The rack code corresponds to
the arrangement of magnets on the base of the rack and is read in by the
Sample Processor in order to recognize the rack. If no rack is in position,
then the display will be empty.
Number of positions
Shows the number of positions on the rack. If no rack is in position, then
the display will be empty.
Shift rate
Sample rack shift rate for manual operation.
Input range 3 - 20 °/s
Default value 20 °/s
[Rack data]
Opens the Rack data dialog window (see Chapter 6.12.3, page 834), in
which the data of the attached rack can be viewed and edited.
[Initialize rack]
Initializes the attached rack. This resets the rack, the lift and the robotic
arm, reads out the rack code and transfers the corresponding rack data to
the Sample Processor.