Metrohm viva 1.1 (ProLab) - Manual (Page 949)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 937
Input range 0% mapping of the input - 100% mapping of
the input 'Mapping unit of the input or of the
calculated value'
Default value 0 'Mapping unit of the input or of the calcu-
lated value'
Actuating variable
Selects the control value from all of the digital outputs of the Controller
output type.
Selection 'Port designation'
'Port designation'
Only digital output ports of the Controller output type can be
selected.
Control task
Selection of the control task.
Selection Digestion unit | Free controller
Default value Digestion unit
NOTE
The control parameters adjust themselves on the basis of permanently
specified parameter sets when the control task is changed. They can,
however, be adjusted.
Input parameters
Tolerance range
for Control task = Digestion unit
Input range
0 - Smallest distance between setpoint value
and 0% mapping or 100% mapping 'Map-
ping unit of the input or of the calculated
value'
Default value 1.0 'Mapping unit of the input or of the cal-
culated value'
for Control task = Free controller
Input range
0 - Smallest distance between setpoint value
and 0% mapping or 100% mapping 'Map-
ping unit of the input or of the calculated
value'
Default value 1 'Mapping unit of the input or of the calcu-
lated value'