Rockwell Automation 5370-CVIM2 Module - Manual (Page 104)

Chapter 4
Inspection Configuration
4–18
•
Result –– Use the button to select the results display setup panel
for the currently selected toolset.
•
Done –– Use the button to save the entries in the Display panel
and exit to the Configuration Editor panel.
Setting Up Image Display Panels
When you pick one of the active image buttons on the Display panel, the
corresponding image display setup panel appears, as is illustrated in
Figure 4.12.
Figure 4.12 Selecting Image Display Setup Panel
ЗЗЗ
ЗЗЗ
ЗЗЗ
ЗЗЗ
Here is a brief description of each field in the image display panel:
•
Title –– This field enables the user to select an appropriate name or “title”
for the corresponding image display panel. By default, the title is initially
the name of the toolset (image display #1), or the toolset name and image
panel number (image panel #2 and #3). Thus, the default titles for the
three
Toolset 1 image panels would be Toolset 1 , Toolset 1 (2) , and
Toolset 1 (3) .
•
Tool Display –– This field enables the user to select the default setting for
the online image display panels. The choices are these:
Image Only ,
Failed Tools , and All Tools .
•
Scale –– This field enables the user to select the scale of the camera
image that appears in the online image display panels, as follows: A scale
of “
1 ” displays the acquired image at its original size, but may only show
a portion of the camera image if the display panel is smaller.