Rockwell Automation 5370-CVIM2 Module - Manual (Page 96)

Chapter 4
Inspection Configuration
4–10
Figure 4.8 Selecting an Inspection Name
ЗЗЗЗ
ЗЗЗЗ
ЗЗЗЗ
ЗЗЗЗ
ЗЗЗЗ
ЗЗЗЗ ЗЗЗ
ЗЗЗ
ЗЗЗ
ЗЗЗЗЗ
ЗЗЗЗЗ
ЗЗЗЗЗ
ЗЗЗЗЗ
The default inspection name, Toolset 1 , appears in the keyboard name bar
initially. You can either accept the default inspection name (if it has not
already been used), or you can select a new name.
If you select the default inspection name, the Configuration Editor panel
will appear as shown in Figure 4.9.
Figure 4.9 Configuration Editor Panel With First Inspection Named