Rockwell Automation 5370-CVIM2 Module - Manual (Page 111)

5 Chapter Chapter 4
Inspection Configuration
4–25
8. Pick the or button. When you do, the Tool Types menu
appears, as shown in Figure 4.19.
Figure 4.19 Tools Types Menu
The Tool Types menu is a “scrolling list” that contains all of the
inspection tool types that are available for any inspection application.
(As noted earlier, this section covers only the general configuration
procedures. For detailed information about the inspection tool types,
refer to Chapter 7, Inspection Tools.)
9. Highlight (pick) one of the tool types, then pick the button. When
you do, the toolset edit panel reappears with the new tool type (“ Gage ,”
in this example) entered in the topmost line, as shown in Figure 4.20.
Figure 4.20 Example: Selecting First Inspection Tool in Toolset Edit Panel
ЗЗЗЗЗЗ
ЗЗЗЗЗЗ
ЗЗЗЗЗЗ
ЗЗЗЗЗЗ
ЗЗЗЗЗЗ