Rockwell Automation 5370-CVIM2 Module - Manual (Page 263)

5 Chapter Chapter 7
Inspection Tools
7–25
•
Fail –– This returns an “error code” when the tool is in a fail condition
and
0.000 for all other conditions. The error code identifies a specific
reason for the failure; for example, error code 1045.000 identifies “High
range fail” as the cause of the inspection failure. The complete list of
error codes and fail conditions appears in Appendix A of this manual.
•
Total –– This returns the total number of inspections performed.
•
Faults –– This returns the total number of faults detected.
•
Fail High –– This returns a 1.000 when the inspection result from the
tool has exceeded the high Fail limit and 0.000 when the result has not
exceeded the high Fail limit.
•
Warn High –– This returns a 1.000 when the inspection result from the
tool has exceeded the high Warn limit (and the tool is not in a fail
condition) and 0.000 when the result has not exceeded the high Warn
limit.
•
Warn Low –– This returns a 1.000 when the inspection result from the
tool has exceeded the low Warn limit (and the tool is not in a fail
condition) and 0.000 when the result has not exceeded the low Warn
limit.
•
Fail Low –– This returns a 1.000 when the inspection result from the
tool has exceeded the low Fail limit and 0.000 when the result has not
exceeded the low Fail limit.
•
Result –– This returns the actual value of the inspection result; that is, the
measurement, count, or other numeric result from the gage tool. This
value corresponds to the “learned” value that appears in the “
Nominal ”
field of the gage tool edit panel.
•
Ax –– This value pertains only to a gage tool configured for linear
measurement, X or Y position, theta, wedge, or chord operations. “Ax”
returns the value of the X coordinate of Feature A.
•
Ay –– This value pertains only to a gage tool configured for linear
measurement, X or Y position, theta, wedge, or chord operations. “Ay”
returns the value of the Y coordinate of Feature A.
•
Bx –– This value pertains only to a gage tool configured for linear
measurement, wedge, or chord operations. “Bx” returns the value of the X
coordinate of Feature B.
•
By –– This value pertains only to a gage tool configured for linear
measurement, wedge, or chord operations. “By” returns the value of the Y
coordinate of Feature B.
•
*Samples –– This returns the current total number of inspection samples
since the start of run operation.