Rockwell Automation 5370-CVIM2 Module - Manual (Page 91)

5 Chapter Chapter 4
Inspection Configuration
4–5
NOTE: If you attempt to exit the Config Files panel at this time by picking
the button, the following message will appear:
This message indicates that the specified configuration file,
“
EE:FrontLabel ,” must contain the name of an “ Acq. Config ” file. You
must enter an Acq. Config file name before exiting the Config File s panel.
A similar message will appear if you attempt to exit without entering a
“
Config ” file name.
If this message appears, pick the button to return to the Config Files
panel and enter an Acq. Config file name.
When you pick Acq. Config field, then pick the button, the keyboard
panel appears as shown in Figure 4.5.
Figure 4.5 Selecting New “Acq. Config” File Name
ЗЗЗЗЗЗЗЗ
ЗЗЗЗЗЗЗЗ
ЗЗЗЗЗЗЗЗ
ЗЗЗЗЗЗЗЗ
ЗЗЗЗЗЗЗЗ
ЗЗЗЗ
ЗЗЗЗ
ЗЗЗЗ
ЗЗЗЗ
The message at the top of the keyboard panel instructs you to: “ Enter a file
name . . . ” That name will become the name of your new Acq. Config file.
Note that the name “ EE:FrontLabel.acq ” appears in the keyboard name
field. This name is derived from the Config file name currently appearing in