Rockwell Automation 5370-CVIM2 Module - Manual (Page 95)

5 Chapter Chapter 4
Inspection Configuration
4–9
Figure 4.7 Example: Configuration Editor Panel With Three inspections Defined
The basic configuration procedure described in this section begins with the
Configuration Editor panel as shown in Figure 4.6 (page 4–7) and steps
through the major system configuration tasks, which are these:
•
Selecting an inspection name.
•
Configuring acquisition parameters.
•
Selecting inspection parameters.
•
Selecting image/results display parameters.
•
Setting up inspection tools.
•
Selecting discrete I/O functions.
Selecting Inspection Name
Note that the Configuration Editor panel in Figure 4.6 contains no
inspection names. Consequently, the , , , and
buttons are inactive (shaded). The , , , and
buttons are all active (white).
The first task, therefore, is to add a toolset by picking the button, or by
picking an Inspection Name field, as shown in Figure 4.8 (page 4–10).
Using either method, the keyboard appears, as shown in Figure 4.8.
Basic Configuration
Procedure