Rockwell Automation 5370-CVIM2 Module User Manual
Page 97
5
Chapter
Chapter 4
Inspection Configuration
4–11
Note that the default inspection name (
Toolset 1
) now appears in the first
field under
Inspection Name
, and the default archive name
(
EE:FrontLabel.ts1
) appears under
Archive Name
.
Configuring Acquisition Parameters
NOTE: The default acquisition parameters are sufficient for obtaining
images without a strobe light or external trigger. You can skip directly to the
Setting Up Inspection Tools section on page 4–20 if you are just getting
started.
At this point you should pick the
button and configure the image
acquisition parameters, which involves the selection of toolset trigger,
camera, and acquisition system parameters. For details about these
parameters, refer to Chapter 3, Image Acquisition Parameters.
Selecting Inspection Parameters
The
Inspection
setup panel is accessible from the
Configuration Editor
panel, as shown in Figure 4.10, by picking the
button.
Figure 4.10 Selecting Inspection Panel
ЗЗЗЗЗЗЗ
ЗЗЗЗЗЗЗ
ЗЗЗЗЗЗЗ
ЗЗЗЗЗЗЗ
ЗЗЗЗЗЗЗ