Rockwell Automation 5370-CVIM2 Module - Manual (Page 60)

5 Chapter Chapter 3
Image Acquisition Parameters
3–21
Pick and Place Functions (Computed Mode Only)
After acquiring an appropriate camera image of the calibration object, as
described under the Image Setup heading on page 3–17, you should pick the
button for the X–axis (or Y–axis) gage, then position the gage so
that it crosses the calibration object along the X–axis (or Y–axis).
Figure 3.13 shows the X–axis and Y–axis gages positioned across an
example calibration object.
Figure 3.13 Calibration Gages Positioned Over Example Calibration Object
Example
calibration
object
Y–axis gage
X–axis gage
If necessary, refer to Chapter 5, Pick and Place Function, for information
about pick and placing gages.