Rockwell Automation 5370-CVIM2 Module - Manual (Page 433)

5 Chapter Chapter 7
Inspection Tools
7–195
•
Gage# –– This returns the results value from a specific sub–gage (for
single math operations) or the results values from several sub–gages (for
multiple math operations).
For single math operations, the pound sign should be replaced with the
number of a specific sub–gage.
For multiple math operations, the pound sign should not be replaced.
•
Ax# –– This value pertains only to a sub–gage tool configured for linear
measurement or X or Y position operations. “Ax” returns the value of the
X coordinate of Feature A.
For single math operations, the pound sign should be replaced with the
number of a sub–gage that is configured for linear measure or X or Y
position operation.
For multiple math operations, the pound sign should not be replaced.
•
Ay# –– This value pertains only to a sub–gage tool configured for linear
measurement or X or Y position operations. “Ay” returns the value of the
Y coordinate of Feature A.
For single math operations, the pound sign should be replaced with the
number of a sub–gage that is configured for linear measure or X or Y
position operation.
For multiple math operations, the pound sign should not be replaced.
•
Bx# –– This value pertains only to a sub–gage tool configured for linear
measurement operations. “Bx” returns the value of the X coordinate of
Feature B.
For single math operations, the pound sign should be replaced with the
number of a sub–gage that is configured for linear measure.
For multiple math operations, the pound sign should not be replaced.
•
By# –– This value pertains only to a gage tool configured for linear
measurement operations. “By” returns the value of the Y coordinate of
Feature B.
For single math operations, the pound sign should be replaced with the
number of a sub–gage that is configured for linear measure.
For multiple math operations, the pound sign should not be replaced.