Rockwell Automation 5370-CVIM2 Module - Manual (Page 349)

5 Chapter Chapter 7
Inspection Tools
7–111
Once you have selected a math tool as outlined in the Overview: Inspection
Tool Selection Process section (page 7–1), you can configure a formula for
that tool by picking the
Math field in the toolset edit panel. (One math tool
must be selected and configured for each formula required in a particular
inspection application.)
When you pick the Math field, the math tool edit panel appears, as shown by
the example in Figure 7.90.
Figure 7.90 Example: Selecting the Math Tool Edit Panel
Math tool name
(default position)
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
ЙЙЙЙЙЙ
Note in Figure 7.90 that the math tool name appears on the screen in its
default name (“
Tool n ”) and position.
The math tool edit panel (named “ Toolset 1.Tool 4 Edit ” in Figure 7.90)
contains several data fields and buttons, which are described briefly as
follows:
•
Operation –– This field selects either the Single operation mode, during
which the math tool produces one result, or the Multiple operation mode,
during which the math tool can produce multiple results when certain
configuration requirements are met. (For details about the
Multiple