Rockwell Automation 5370-CVIM2 Module - Manual (Page 253)

5 Chapter Chapter 7
Inspection Tools
7–15
Figure 7.14 Example: Reporting the X Coordinate of a Single Edge
ЗЗЗ
ЗЗЗ
ЗЗЗ
ЗЗЗ
Y Position
This gage operation is available when you select either the binary gaging
mode or the gray scale gaging mode. The Y position operation measures the
absolute vertical position of a specified edge along the length of a gage. The
Y position is reported in pixels, with the origin (0 coordinate) being the top
boundary of the image.
Figure 7.15 shows a linear gage using the Y position operation. In this
example, the Y–axis position of the selected edge is 212 pixels from the top
boundary of the image.
Figure 7.15 Example: Reporting the Y Coordinate of a Single Edge
ЗЗЗЗЗЗ
ЗЗЗЗЗЗ
ЗЗЗЗЗЗ
ЗЗЗЗЗЗ