Rockwell Automation 5370-CVIM2 Module - Manual (Page 497)

5 Chapter Chapter 10
Environment Menu Selections
10–11
When you pick Comm Ports in the Environment menu, the Comm Ports
selection menu appears, as shown in Figure 10.13. When you then pick
Remote I/O Configuration , the remote I/O port configuration panel appears
as shown in the figure.
Figure 10.13 Example: Selecting the Remote I/O Port Configuration Panel
ЗЗЗЗЗ
ЗЗЗЗЗ
ЗЗЗЗЗ
The CVIM2 system has one physical Remote I/O port on the front panel,
and it is used for data communications with Allen–Bradley PLC
 processors
or 6008SI interface cards.
To configure the remote I/O port, select the appropriate data rate and rack
address, then pick the
button. When you do, the panel disappears and
the main menu bar is once again active.
When you pick Comm Ports in the Environment menu, the Comm Ports
selection menu appears, as shown in Figure 10.14 (page 10–12). When you
then pick
Discrete Outputs , the Discrete Outputs configuration panel
appears as shown in the figure.
The top two fields in this panel enable you to control the state of the discrete
outputs during online operations. The bottom field displays the test/runmode
status of the programmable logic controller connected to the remote I/O port.
Remote I/O Serial Port
Setup
Enable/Disable Discrete
Outputs