Rockwell Automation 5370-CVIM2 Module - Manual (Page 120)

Chapter 4
Inspection Configuration
4–34
Alternate Toolset Save Option
If, after you add tools to a toolset, the proposed storage device (such as
“EE:”) is full and cannot accept the enlarged toolset file, a warning message
will appear when you pick the
button, as shown in Figure 4.24:
Figure 4.24 Warning Message When Toolset File Cannot Be Saved in Current Device
In order to save an amended toolset when you see this warning message, you
must select an alternate storage device, such as the memory card, “MC:”
To save the toolset changes, pick the button on the warning message
panel. When you do, the “ Save as . . . ” panel appears, as shown in
Figure 4.25.
Figure 4.25 Selecting a New Device For Toolset Storage
ЗЗЗЗЗ
ЗЗЗЗЗ
ЗЗЗЗЗ
NOTE: If you were to pick the button on the “ Save as . . . ” panel
at this time, the panel would exit back to the toolset edit panel. If you then
picked the
button in the toolset edit panel, any changes that you
made to the toolset would be lost.