Rockwell Automation 5370-CVIM2 Module - Manual (Page 472)

5 Chapter Chapter 9
Discrete I/O Assignments
9–9
Output Selections
As noted earlier, the lower 14 discrete I/O locations in the Module I/O layout
are reserved for output signals only. To assign an output signal, pick one of
the corresponding boxes under the
Signal Name heading. When you do, the
Output Signals panel appears, as illustrated by the example in Figure 9.5.
Figure 9.5 Example: Selecting the Output Signals Panel
ЗЗЗЗЗ
ЗЗЗЗЗ
ЗЗЗЗЗ
ЗЗЗЗЗ
Note that this panel contains three scrolling lists. The left list contains signal
names that relate to the toolsets in the currently selected configuration file,
and to the configuration generally. The center list contains signal names that
pertain to results from specific toolsets. The right list contains signal names
that pertain to results from specific tools within a specific toolset. (Note that
the center and right panels are empty, initially.)
The signal names appearing in the left scrolling list are described briefly as
follows:
•
Toolset n –– This is the generic name for a toolset. It cannot be selected
alone; it is always selected in conjunction with a toolset–related selection
in the center panel, or with a toolset selection and a tool–related selection
in the right panel.
•
Module Ready –– This signal is active continuously when the CVIM2
system is online and is able to process inspections; otherwise, it is
inactive.
•
Bank State –– This signal indicates whether cameras 1, 2, and 3 are
active, or cameras 4, 5, and 6.
•
Toolset Edit –– This signal indicates that the system is online and ready
for inspections, and the toolset edit panel is open.