Rockwell Automation 5370-CVIM2 Module - Manual (Page 105)

5 Chapter Chapter 4
Inspection Configuration
4–19
A scale of “ To Fit ” displays the entire camera image completely within
the image display panel, regardless of the panel’s size. Since the “ To Fit ”
mode may cause the image to be “shrunken” to fit in the panel, some
image details may not be displayed.
•
Panel Position –– This parameter reflects the X– and Y–axis coordinates
of the upper–left and lower–right corners, respectively, of the image panel
for currently selected toolset in the
Configuration Editor panel (as
illustrated in Figure 4.15 on page 4–22). When you pick the Panel
Position field, the image panel (and the results panel) for the selected
toolset appear on the screen, and both panels are accessible for resizing
and repositioning on the screen. (The image and results panels for other
toolsets are also available at this time; however, they may appear on the
screen as icons.)
•
Start Iconized ? –– This field enables the user to determine whether
online operations begin with the full image display panel on the screen
(“
No ”), or with an icon representing the panel appearing at the right side
of the screen (“ Yes ”). The default selection is “ No .”
•
Source Image –– This field enables the user to select the camera source,
if the current toolset has been configured to use more than one camera.
Setting Up Results Display Panels
When you pick the button on the Display panel, the Results display
setup panel for the currently selected toolset appears, as is illustrated in
Figure 4.13.
Figure 4.13 Selecting Results Display Setup Panel
ЗЗ
ЗЗ
ЗЗ
ЗЗ