Rockwell Automation 5370-CVIM2 Module - Manual (Page 215)

Chapter 6
Reference Tools
6–56
The reference line tool is configured for “X then Y” operation, with the X–
and Y–axes crossing through the center of the circular object, as shown in
Figure 6.46. The function of the tool is to locate the center of the circular
object; thus, offsets (such as “
Center ”) should be selected for this purpose.
Figure 6.46 Example: X Then Y Reference Line Configured Over Circular Object
Reference
line tool axes
The source window is centered over the circular object as shown in
Figure 6.47, and its rings are set so that the circular object nearly fills the
space between them.
Figure 6.47 Example: Source Window Rings Positioned Over Circular Object
Source
window
Destination
window