Rockwell Automation 5370-CVIM2 Module - Manual (Page 110)

Chapter 4
Inspection Configuration
4–24
Figure 4.17 Example: Camera Image in Setup Mode Image/Tool Display Panel
6. If an external trigger source is used, send a trigger signal to the CVIM2
system. When you do, a camera image appears in the display panel.
7. Pick Tools in the menu bar. When you do, the toolset edit panel (the
inspection tool setup panel) appears over the image/tool display panel, as
shown in Figure 4.18.
Initially, the toolset edit panel is empty, as shown in Figure 4.18. To enter
the first inspection tool, continue with these steps:
Figure 4.18 Initial State of the Toolset Edit Panel