Rockwell Automation 5370-CVIM2 Module User Manual

Page 18

Advertising
background image

Chapter 1

Hardware Connection and Powerup Check

1–6

Connecting the User Interface Cable (2801–NC20A, B, C): VGA
Monitor

Use the following steps to connect the user interface cable when a VGA
monitor is to be used:

1. Locate the user interface cable, Catalog No. 2801–NC20A, B, or C, and

the user interface module, Catalog No. 2801–N26.

NOTE: The two ends of this cable are identical.

2. Connect either end of the cable to the

User Interface

connector on the

CVIM2 front panel. Tighten the screws.

3. Connect the other end of the cable to the

CVIM2

connector on the user

interface module. Tighten the screws.

4. Connect the 15–pin connector on the VGA monitor cable to the

VGA

MONITOR

connector on the user interface module.

5. Connect the light pen, if used, to the

LIGHT PEN

socket on the user

interface module.

Connecting the User Interface Cable (2801–NC19A, B, C): N8 Monitor

Use the following steps to connect the user interface cable when an
Allen–Bradley 2801–N8 color monitor is to be used:

1. Locate the user interface cable, Catalog No. 2801–NC19A, B, or C.

2. Connect the 15–pin connector on the cable to the

User Interface

connector on the CVIM2 front panel. Tighten the screws.

3. Connect the other end of the cable to the

VIDEO INPUT

connector on

the rear panel of the N8 color monitor.

4. Connect the light pen, if used, to the

LIGHT PEN

socket on the N8

monitor front panel.

Connecting the User Interface Cable (2801–NC19A, B, C): Other
RS–170 Monitors

Use the following steps to connect the user interface cable when a monitor
other than the Allen–Bradley 2801–N8 is to be used:

1. Locate the user interface cable, Catalog No. 2801–NC19A, B, or C, and

the user interface box, Catalog No. 2801–N22.

2. Connect the 15–pin connector on the cable to the

User Interface

connector on the CVIM2 front panel. Tighten the screws.

3. Connect the other end of the cable to the

INPUT

connector on the N22

box.

4. Connect the light pen, if used, to the

LIGHT PEN

socket on the user

interface module.

Advertising
Popular Brands
Popular manuals