Yaskawa MotionWorks IEC - Manual (Page 347)

PLCopenPlus Function Blocks for Motion Control 2013-04-13 339
8470 ExceededMaxTypeCount A user log item can only support eight inputs for each
type.
8471 SaveLogFailed Saving the log failed.
Communication Errors
8705 MaxUserFDLimit Exceeded maximum number of open user IO devices
8706 InvalidUserFDHandle Invalid user IO device handle
8707 InvalidMasterSlave Invalid IP address
8708 SocketCreateFailed Socket initialization failed
8709 AddressInUse The address is already in use on the local network
8710 AddressUnavailable Address Unavailable
8711 AcceptFailed Accept Connection Failed
8712 BindFailed Bind Failed
8713 InvalidSocketType Invalid Socket Type
8714 InvalidBindAddress Invalid Bind Address
8715 ConnectSocketFailed Connecting to the socket failed
8716 AddressUnreachable The remote IP address is unreachable. Check the
default gateway
8717 SocketAlreadyConnected The socket is already connected
8718 ConnectionRefused The connection was refused by the remote device
8719 SocketNotConnected No TCP socket is connected
8720 DeviceOptionError Device Option Error
8721 DeviceReadFailed Reading from the comm device has failed
8722 DeviceWriteFailed Device Writing has failed
8723 InvalidDeviceIOBuffer Invalid Device IO Buffer
8724 InvalidDeviceOptionID Invalid Device Option ID
8725 InvalidDeviceOptionValue An option specified for the device is invalid
8726 InvalidSerialPort The serial port specified is invalid
8727 SerialPortOpenFailed The serial port specified could not be opened
Axis Errors
40960 ServoPackAlarms RESERVED
45332 ClearAlarmsFailed Sending clear alarms command to servo drive failed.
45333 MechatrolinkResetFailed
45334 MechatrolinkResetProhibited Function cannot be utilized if there is a servo enabled
or in motion on the network.
45335 AbsoluteEncoderInitializationFailed Failed to initialize absolute encoder.
45336 DownloadInProgress Function block could not be executed because a
program download was in progress.
44337 Rebooting the controller is prohibited Rebooting the controller is prohibited while an axis is