Lenze ECSCPxxx - Manual (Page 236)

Commissioning
E−Shaft: Speed−dependent angular trimming
6
l
236 EDBCSXP064 EN 8.0
Code Possible settings IMPORTANT
No. Designation Lenze/
{Appl.} Selection
C4060 ES_NOffs Only for "electrical shaft"
function: default value (in
increments) for
speed−proportional angular
trimming relating to
15000 rev./min.
Note: Only change value when
the controller is at standstill! ^ 235
−655360 {1 inc} 655360
C4061 ES_ActN
Offset
Only for "electrical shaft"
function: Currently active value
of the angular trimming relating
to 15000 rev./min at current
speed.
Read only ^ 235