Lenze ECSCPxxx - Manual (Page 407)

Appendix
Code table
12
l
407 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C4023 Brk: N_Thresh 0.1 % Speed threshold for brake
activation ^ 130
0.00 {0.01 %} 10.00
C4040 AppControl 0 Control word to the drive
Only active if C4010 = 3.
^ 158
0 {1} 65535
C4041 App−Rx−W2 0 Data word 2 to the drive
Only active if C4010 = 3.
−32767 {1} 32767
C4042 App−Rx−W3/4 0 Double data word 3/4 to the
drive
Only active if C4010 = 3.
−2147483647 {1} 2147483647
C4045 AppState 1 Status word 1 from the drive
l Read only
^ 161
0 {1} 65535
C4046 AppState 2 Status word 2 from the drive
l Read only
^ 161
0 {1} 65535
C4047 App−Tx−W2 0 Data word 2 from the drive
−32767 {1} 32767
C4048 App−Tx−W3 0 Data word 3 from the drive
−32767 {1} 32767
C4049 App−Tx−W3/4 0 Double data word 3/4 from the
drive
−2147483647 {1} 2147483647
C4050 PosProfSel Number of the selected
positioning profile
Only display
0 {1} 15
C4052 PO: Ctrl (W1) Currently effective control word
Ctrl1
Read only
0 {1} 65535
C4053 PO: W2 Currently effective VelDirect
value
Read only
−32767 {1} 32767
C4054 PO: W3/4 Currently effective PosDirect
value
Read only
−2147483647 {1} 2147483647
C4060 ES_NOffs Only for "electrical shaft"
function: default value (in
increments) for
speed−proportional angular
trimming relating to
15000 rev./min.
Note: Only change value when
the controller is at standstill! ^ 235
−655360 {1 inc} 655360