Lenze ECSCPxxx - Manual (Page 371)

Appendix
Code table
12
l
371 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0361 Detected load
CAN_IN/CAN_OUT (CAN bus
interface X4)
Read only
A faultless operation is only
guaranteed if the total bus load
of all connected nodes amounts
to a value
£ 80 %.
^ 288
1 Load IN/OUT 0 {1 %} 100 All sent telegrams
2 Load IN/OUT All received telegrams
3 Load IN/OUT Sent to CAN1_OUT
4 Load IN/OUT Sent to CAN2_OUT
5 Load IN/OUT Sent to CAN3_OUT
6 Load IN/OUT Sent on parameter data
channel 1
7 Load IN/OUT Sent on parameter data
channel 2
8 Load IN/OUT Received from CAN1_IN
9 Load IN/OUT Received from CAN2_IN
10 Load IN/OUT Received from CAN3_IN
11 Load IN/OUT Received from parameter data
channel 1
12 Load IN/OUT Received from parameter data
channel 2
C0362 Sync cycle Time interval between 2 sync
telegrams via the X4 CAN bus
interface or EMF2192IB EtherCAT
communication module at X1 AIF
interface
Read only ^ 278
1 {1 ms} 30
C0363 Sync correct. 1 Sync correction increment (for
CAN and EtherCAT)
l Change correction value until
C4264 reaches the minimum.
^ 279
1 0.2 ms/ms
2 0.4 ms/ms
3 0.6 ms/ms
4 0.8 ms/ms
5 1.0 ms/ms
C0365 DIS:CAN
active
Input signal CAN active
Only display
0 CAN not active
1 CAN active
C0366 Sync Response 1 CAN sync response for interface
X4 (CAN)
The value "1" should always be
set! ^ 281
0 No response
1 Response