Lenze ECSCPxxx - Manual (Page 404)

Appendix
Code table
12
l
404 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C3096 Additional function for
positioning profile 1 ... 15 ^ 96
1 Prof.Func1 0 No function Additional function for
positioning profile 1
... ... ... ... ...
15 Prof.Func1 0 No function Additional function for
positioning profile 15
0 65535 The controller interprets the
information in bit codes (16 bits).
0000.0000.0000.0000: No function No function
xxxx.xxxx.xxxx.xxx1: Vel_Ovr_Ain Speed override is activated via
analog input.
xxxx.xxxx.xxxx.xx1x: pos_>Mlim Torque limitation after
positioning
xxxx.xxxx.xxxx.x1xx: ProfEnable_>Con
tinue
Profile continuation after profile
stop
xxxx.xxxx.xxxx.1xxx: Vel_Ovr_PDO Speed override is activated via
PDO "Rx_par1" (CAN, AIF,
C4041).
xxxx.xxxx.xxx1.xxxx: Direct change Immediate profile change during
positioning
C3097 Function parameter 1 for
positioning profiles 1 ... 15
Use:
l Torque limitation after
positioning (
^ 208)
l Stretch factor numerator for
positioning profile mode
C3095/x = 30/31 (electrical
shaft,
^ 196)
1 ProfFuncPar1 0 −2147483647 {1} 2147483647
... ... ...
15 ProfFuncPar1 0
C3098 Function parameter 2 for
positioning profiles 1 ... 15
Use:
l Torque limitation after
positioning (
^ 208)
l Stretch factor denominator
for positioning profile mode
C3095/x = 30/31 (electrical
shaft,
^ 196)
1 ProfFuncPar2 0 −2147483647 {1} 2147483647
... ... ...
15 ProfFuncPar2 0
C3100 Parameter "Target position" for
positioning profiles 1 ... 15
Note: Input value must be within
the range of the
± value
from C4265.
l Example: C4265 = 10000 ð
value range −10000 ... +10000
^ 97
1 Prof.Position 0 −214000.0000 {0.0001
units}
214000.0000
... ... ...
15 Prof.Position 0