Lenze ECSCPxxx - Manual (Page 400)

Appendix
Code table
12
l
400 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C3035 DwellTime 50 Dwell time after end of profile ^ 232
0 {1 ms} 65535 Time required from positioning
profile end (setpoint generator
has reached target position) to
the setting of status bit
Stat1.DwellTime = 1
C3036 BounceTime 0 Debounce time for touch probe
input
0 {0.001 ms} 65535
C3040 SW−LimPos 3600.0 Positive software limit position
^ 237
0.0000 {0.0001
units}
214000.0000
C3041 SW−LimNeg −3600.0 Negative software limit position ^ 237
−214000.0000 {0.0001
units}
0.0000
C3042 SWLimCtrl
Mode
0 Mode of the software limit
position monitoring
0 Current setpoint position +
defined direction of movement
1 Current actual position
C3050 Act. position Current position in increments
Read only
−2.147.483.647 {1 inc} 2.147.483.647
C3051 Current
position
Current position in units
Read only
−214000.0000 {0.0001
units}
214000.0000 The display is limited to +/−
214000.0000
C3052 Act. profile l Control bit
Ctrl1.ProfEnable = 1:
Number of the positioning
profile currently active or
executed last
l Control bit
Ctrl1.ProfEnable = 1 or 0:
After cancelling the active
profile, the profile number 0
is displayed.
Read only
0 {1} 15
C3053 Current
velocity
Current speed in units/s
Read only
−214000.0000 {0.0001
units/s}
214000.0000
C3056 ActTargetPos Current target position/distance
in increments (inc)
−2.147.483.647 {1 inc} 2.147.483.647
C3057 TargetPosReal Current target position/distance
in units
−214000.0000 {0.0001
units}
214000.0000