Lenze ECSCPxxx - Manual (Page 372)

Appendix
Code table
12
l
372 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0367 Sync Rx ID 128 CAN sync receipt ID for CAN bus
interface X4 ^ 280
1 {1} 256
C0368 Sync Tx Id 128 CAN Sync transmission ID for
CAN bus interface X4 ^ 414
^ 278
1 {1} 256
C0369 SyNc Tx time 0 CAN sync transmission cycle for
CAN bus interface X4
A sync telegram with the
identifier of C0368 is sent with
the cycle time set.
ECSxP: The setting is effected
automatically depending on
C4062! ^ 279
0 {1 ms} 65000 0 = switched off
[C0370] SDO gateway 0 Activate address
gateway/remote
parameterisation
l C0370 ¹ 0: All code
write/read accesses are
redirected to the CAN node
with the CAN node address
set here.
l The corresponding code is
accessed via parameter data
channel 1 of the target device.
l C0370 = 0: remote
parameterisation is
deactivated
^ 289
0 {1} 63
C0371 Gateway Ch. 1 Selection of the gateway channel ^ 289
0 CAN Use CAN bus interface X4
1 CAN−AUX Use CAN bus interface X14
C0381 HeartProdTim
e
0 Heartbeat (slave):
HeartbeatProducerTime
l Time interval for sending the
heartbeat message
l Only relevant for setting
C0352 = 3.
0 {1 ms} 65535
C0382 GuardTime 0 Node Guarding (slave):
NodeGuardTime
l Time interval of the status
inquiry of the master
l Only relevant for setting
C0352 = 4.
^ 284
0 {1 ms} 65535
C0383 LifeTimeFact 0 Node Guarding (slave):
NodeLifeTime factor
l Factor for the monitoring
time of NodeLifeTime
l NodeLifeTime = C0383 x
C0382 (NodeGuardTime)
l Only relevant for setting
C0352 = 4.
^ 284
0 {1} 255