Lenze ECSCPxxx - Manual (Page 399)

Appendix
Code table
12
l
399 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C3013 Homing Vel 720.0 Homing speed
1.0000 {0.0001
units/s}
214000.0000
C3014 Homing Acc 720.0 Homing acceleration
1.0000 {0.0001
units/s 2 }
214000.0000
C3015 HomJerkTime 0.0 Homing − jerk time
0.000 {0.001 ms} 10.000
C3017 Lim.n=0−Flag 0.10 Limit value for speed, (n
min
signal)
^ 231
0.01 {0.01 %} 100.00 If the value falls below the limit
value, the status bit Stat2.Nmin
is set to 1.
C3018 Hyst.n=0−Flag 0.10 Hysteresis for speed (n
min
signal) ^ 231
0.00 {0.01 %} 100.00
C3020 ManualVel 360.0 Traversing speed for manual jog
(inching mode) ^ 173
0.0001 {0.0001
units/s}
214000.0000
C3021 ManualAcc 720.0 Acceleration for manual jog
(inching mode) ^ 173
0.0001 {0.0001
units/s 2 }
214000.0000
C3022 ManualDec 720.0 Deceleration for manual jog
(inching mode) ^ 173
0.0001 {0.0001
units/s 2 }
214000.0000
C3030 FollErrWarn 360.0 Following error tolerance
(warning)
^ 233
0.0000 {0.0001
units}
214000.0000 If the tolerance is exceeded, the
"FollowErr" warning will be
triggered. The status bit
Stat2.FollowErrWarn is set to "1"
(TRUE).
Note: The acceptance of changed
settings requires a status change
via the "Stand−By" status!
C3031 FollowErrQSP 720.0 Following error tolerance
(Fail−QSP) ^ 233
0.0000 {0.0001
units}
214000.0000 If the tolerance is exceeded, the
Fail−QSP "FollowErr" fault is
triggered and the drive is
stopped through the QSP ramp.
Note: The acceptance of changed
settings requires a status change
via the "Stand−By" status!
C3034 Target
Window
360.0 Total width of the target position
window
Layout: Half of the window
width before and after the target
position ^ 229
−0.0000 {0.0001
units}
65536.0000