Lenze ECSCPxxx - Manual (Page 387)

Appendix
Code table
12
l
387 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C1202 Gear num 1 Gearbox factor numerator
The gearbox ratio specifies the
number of revolutions of the
motor axis at which the load
revolves exactly once.
l i = Z2 / Z1 (ratio of the
number of teeth or
circumferences)
l i = n1 / n2 (ratio of the
speeds)
^ 103
1 {1} 65535
C1203 Gear denom 1 Gearbox factor denominator ^ 103
1 {1} 65535
C1204 Feed const 360.0 The feed constant specifies the
path (in units) which the load
(slide) covers in one revolution. ^ 103
0.0001 {0.0001
units/rev}
214000.0000
C1240 Vel_max 18000.0 Max. permissible speed of the
load (slide).
Note: Enter the motor speed
resulting from Vel_max plus 10%
reserve in C0011! ^ 103
0.0001 {0.0001
units/s}
214000.0000
C1250 Acc_max 36000.0 Max. acceleration
Note: This parameter among
other things depends on the
motor torque and the moment
of inertia of the entire mechanics
driven during the positioning
process! ^ 103
0.0001 {0.0001
units/s 2 }
214000.0000
C1256 S−RMP: Jerk 1.0 The max. jerk is defined
according to a selected time
(t
jerk_max
) after which the max.
acceleration (a
max
) is reached.
Note:
If disproportionately high S−ramp
times (jerk times) are set for
short accelerating times, the
profile may be generated
incorrectly!
0.000 {0.001 s} 10.000
C1810 SW ID LECOM Software identification LECOM
Only display
C1811 SW date
LECOM
Software creation date LECOM
Only display
C2100 Time slice 13 Time slice for cyclic task
6 {1 ms} 26