2 reset fault messages (trip-reset), Reset fault messages (trip−reset), Troubleshooting and fault elimination – Lenze ECSCPxxx User Manual
Page 352
Troubleshooting and fault elimination
Fault messages
Reset fault messages (TRIP−RESET)
l
352
EDBCSXP064 EN 8.0
11.3.2
Reset fault messages (TRIP−RESET)
Response
Measures to reset the fault message
TRIP/FAIL−QSP
Note!
As long as a TRIP/FAIL−QSP source is active, the TRIP/FAIL−QSP cannot be reset.
The TRIP/FAIL−QSP can be reset by:
l
Press keypad XT EMZ9371 BC
ð S. Then, press U to re−enable the axis module.
l
Set code C4166 = 1.
l
Control word "Ctrl1": Control bit Ctrl1.TripReset (
^ 158)
(Dependent on the control interface selected in C4010.)
l
Control word AIF (from V3.0)
After the TRIP/FAIL−QSP has been reset, the drive remains at standstill.
Message
Danger!
After the fault has been removed, the fault message is removed automatically and the drive
restarts automatically.
Warning
After eliminating the fault, the fault message is reset automatically.