Lenze ECSCPxxx - Manual (Page 402)

Appendix
Code table
12
l
402 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C3066 ProfilerState State of the profile generator
Only display
15690 InvProfDist Selected distance is too long or
not plausible!
15700 InvProfPar Invalid profile parameter, travel
is not possible!
15788 ProfAuxVelEq0 Invalid value for speed of the
touch probe positioning;
e. g. value = 0
15789 ProfAuxDecEq0 Invalid value for deceleration of
the touch probe positioning;
e. g. value = 0
15790 ProfAuxAccEq0 Invalid value for acceleration of
the touch probe positioning;
e. g. value = 0
15798 ProfVelEq0 Invalid value for speed;
e. g. value = 0
15799 ProfDecEq0 Invalid value for deceleration;
e. g. value = 0
15800 ProfAccEq0 Invalid value for acceleration;
e. g. value = 0
16000 NoAction No action
16001 PosDone Positioning has been completed.
16010 Acceleration Acceleration phase
16011 ConstSpeed Constant travel phase (final
speed has been reached)
16012 Deceleration Deceleration phase
16013 Reversing Direction of rotation is reversed.
16100 ResetActive Profile generator is reset to the
initial state.
16300 OverflowIntPos Overflow of the internal position
integral
16101 LoadStartVal Profile generator is loaded with
starting values.
16102 AbortActive Positioning stopped
16103 ExtSetVal External setpoint source is active.
16200 NoTPDetected No touch probe signal