Lenze ECSCPxxx - Manual (Page 390)

Appendix
Code table
12
l
390 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C2354 Alternative node addresses for
XCAN_IN/XCAN_OUT
(AIF interface X1)
1 XCAN addr. 129 1 {1} 512 XCAN1_INaddress 2
2 XCAN addr. 1 XCAN1_OUTaddress 2
3 XCAN addr. 257 XCAN2_INaddress 2
4 XCAN addr. 258 XCAN2_OUTaddress 2
5 XCAN addr. 385 XCAN3_INaddress 2
6 XCAN addr. 386 XCAN3_OUTaddress 2
C2355 Identifier for
XCAN_IN/XCAN_OUT
(AIF interface X1)
Read only
1 XCAN Id 1 {1} 2047 Identifier XCAN1_IN
2 XCAN Id Identifier XCAN1_OUT
3 XCAN Id Identifier XCAN2_IN
4 XCAN Id Identifier XCAN2_OUT
5 XCAN Id Identifier XCAN3_IN
6 XCAN Id Identifier XCAN3_OUT
C2356 Time settings for XCAN
(AIF interface X1)
1 XCAN times 0 0 {1 ms} 65000 XCAN boot−up time:
Delay time after mains
connection for initialisation
through the master.
2 XCAN times 0 XCAN1...3_OUT cycle times:
Factor for the task time to send
process data object.
0 = event−controlled
transmission
3 XCAN times 0
4 XCAN times 0
5 XCAN times 0 Delay time for initial
transmission of the process data
objects after the NMT status
changed to "Operational"
C2357 Monitoring time for XCAN
process data input objects
(AIF interface X1)
Only ECSxA: When the subcodes
1 ... 4 are set, consider the task
runtime:
C2357/1...4 = Desired monitoring
time / task runtime
1 CE monit time 3000 1 {1 ms} 65000 XCAN1_IN monitoring time
2 CE monit time 3000 XCAN2_IN monitoring time
3 CE monit time 3000 XCAN3_IN monitoring time
4 CE monit time 3000 Bus−off
5 CE monit time 3000 AIF monitoring time (can only be
set if C2357/6 = 0)
6 CE monit time 0 Sync monitoring time (can only
be set if C2357/5 = 0)
C2359 AIF HW Set. 0
0 {1} 65535