Lenze ECSCPxxx - Manual (Page 393)

Appendix
Code table
12
l
393 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C2454 Alternative node addresses for
CANaux_IN/CANaux_OUT (CAN
bus interface X14) ^ 271
1 CANa addr. 129 1 {1} 512 CANaux1_INaddress 2
2 CANa addr. 1 CANaux1_OUTaddress 2
3 CANa addr. 257 CANaux2_INaddress 2
4 CANa addr. 258 CANaux2_OUTaddress 2
5 CANa addr. 385 CANaux3_IN address 2
6 CANa addr. 386 CANaux3_OUT address 2
C2455 Identifier for
CANaux_IN/CANaux_OUT (CAN
bus interface X14)
Read only
^ 429
1 CANa Id 1 {1} 2047 Identifier CANaux1_IN
2 CANa Id Identifier CANaux1_OUT
3 CANa Id Identifier CANaux2_IN
4 CANa Id Identifier CANaux2_OUT
5 CANa Id Identifier CANaux3_IN
6 CANa Id Identifier CANaux3_OUT
C2456 CAN time settings for CAN bus
interface X14 (CAN−AUX) ^ 274
1 CANa times 3000 0 {1 ms} 65000 CAN−AUX boot−up time:
Delay time after mains
connection for initialisation
through the master.
2 CANa times 0 CANaux2...3_OUT cycle times:
Factor for the task time to send
process data telegram.
0 = event−controlled
transmission
3 CANa times 0
4 CANa times 20 Delay time for initial
transmission of the process data
objects 2 and 3 after the CAN bus
changed to "Operational"
C2457 Monitoring time for
CANaux1...3_IN (CAN bus
interface X14) ^ 297
1 CE monit time 3000 1 {1 ms} 65000 CE11 monitoring time
2 CE monit time 3000 CE12 monitoring time
3 CE monit time 3000 CE13 monitoring time
C2458 Reset node 0 Resetting a node
(CAN bus interface X14) ^ 276
0 No function
1 CAN−AUX reset
C2459 CANa state CAN bus status (CAN bus
interface X14)
Read only ^ 286
0 Operational
1 Pre−operational
2 Warning
3 Bus off