Lenze ECSCPxxx - Manual (Page 403)

Appendix
Code table
12
l
403 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C3095 Mode selection for positioning
profiles 1 ... 15 ^ 191
1 Prof.Mode 1 modulo pos. Positioning profile 1
... ... ... ... ...
15 Prof.Mode 1 modulo pos. Positioning profile 15
0 absolute pos. Absolute positioning
1 modulo pos. Relative positioning in
continuous measuring system
2 speed mode Constant traversing
3 relative pos. Relative positioning with
absolute reference
10 absTP−rel_E3+ Absolute touch probe
positioning (positive edge at
X6/DI3)
11 modTP−rel_E3+ Relative touch probe positioning
(positive edge at X6/DI3)
13 relTP−rel_E3+ Relative touch probe positioning
with absolute reference (positive
edge at X6/DI3)
20 absTP−rel_E3− Absolute touch probe
positioning (negative edge at
X6/DI3)
21 modTP−rel_E3− Relative touch probe positioning
(negative edge at X6/DI3)
23 relTP−rel_E3− Relative touch probe positioning
with absolute reference
(negative edge at X6/DI3)
30 EShaftX8_IS Electrical shaft with setpoint via
X8 and instant start
31 EShaftX4_IS Electrical shaft with setpoint via
X4 and instant start
100 homing Homing
101 set home pos. Set home position
102 reset home pos. Reset home position
110 abs. direct Absolute positioning (direct)
111 mod direct Relative positioning in
continuous measuring system
(direct)
112 speed direct Continuous constant travel
(direct)
113 rel. direct Relative positioning with
absolute reference (direct)
251 mod cycle +/− Positioning sequence for
controller optimisation
l The distance travelled in
positive/negative direction is
selected under C3100.