Lenze ECSCPxxx - Manual (Page 369)

Appendix
Code table
12
l
369 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0352 CAN mst 0 Boot−up master/slave
configuration for CAN bus
interface X4 ^ 273
0 Slave
1 Master boot−up Device is active as CAN boot−up
master.
2 Master node guarding
3 Slave heartbeat producer
4 Slave node guarding
C0353 Source for node address of
CAN_IN/CAN_OUT (CAN bus
interface X4) ^ 271
1 CAN addr sel 0 CAN node address (C0350) Address CAN1_IN/OUT
2 CAN addr sel 0 CAN node address (C0350) Address CAN2_IN/OUT
3 CAN addr sel 0 CAN node address (C0350) Address CAN3_IN/OUT
0 C0350 (auto) Automatically determined by
C0350.
1 C0354 (man.) Determined by C0354.
C0354 Alternative node address for
CAN_IN/CAN_OUT (CAN bus
interface X4) ^ 271
1 CAN addr. 129 1 {1} 512 Address 2 CAN1_IN
2 CAN addr. 1 Address 2 CAN1_OUT
3 CAN addr. 257 Address 2 CAN2_IN
4 CAN addr. 258 Address 2 CAN2_OUT
5 CAN addr. 385 Address 2 CAN3_IN
6 CAN addr. 386 Address 2 CAN3_OUT
C0355 Identifier for CAN_IN/CAN_OUT
(CAN bus interface X4)
Read only ^ 429
1 CAN Id 1 {1} 2047 Identifier CAN1_IN
2 CAN Id Identifier CAN1_OUT
3 CAN Id Identifier CAN2_IN
4 CAN Id Identifier CAN2_OUT
5 CAN Id Identifier CAN3_IN
6 CAN Id Identifier CAN3_OUT
C0356 CAN time settings for CAN bus
interface X4
^ 274
1 CAN times 3000 0 {1 ms} 65000 CAN boot−up time:
Delay time after mains
connection for initialisation
through the master.
2 CAN times 0 CAN2...3_OUT cycle times:
Factor for the task time to send
process data telegram.
0 = event−controlled
transmission
3 CAN times 0
4 CAN times 20 Delay time for initial
transmission of the process data
objects 2 and 3 after the CAN bus
changed to "Operational"