Lenze ECSCPxxx - Manual (Page 355)

Appendix
Code table
12
l
355 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0027 Gain for relative analog signals
(AIN)
1 FCODE(gain) 100,0 −199,99 {0.01 %} 199,99 FCODE_nC27_1_a
2 FCODE(gain) 100,0 FCODE_nC27_2_a
C0030 DFOUT const 3 Constant for the digital
frequency signal DFOUT_nOut_v
on X8 in increments per
revolution ^ 136
^ 145
0 256 incr./rev
1 512 incr./rev
2 1024 incr./rev
3 2048 incr./rev
4 4096 incr./rev
5 8192 incr./rev
6 16384 incr./rev
C0034 Mst current 0 Master voltage/master current
on analog input (AIN1_nIn_a)
0 −10 ... + 10 V Master voltage
1 +4 ... +20 mA
Master current
2 −20 ... +20 mA
C0037 Set−value rpm 0 Setpoint selection in rpm
(FCODE_nC37_a)
−16000 {1 rpm} 16000
C0040 Ctrl enable 1 Controller enable / controller
inhibit (CINH)
l Writing: Controls the
controller inhibit
l Reading: Reads the status of
the controller inhibit
0 Controller inhibited
1 Controller enabled
C0042 DIS: QSP Quick stop status (QSP)
Only display ^ 243
0 QSP not active
1 QSP active
C0043 Trip reset 0 Reset active fault message
(TRIP−RESET) ^ 352
0 Reset fault message (TRIP−RESET) / no
fault
1 Active fault message
C0050 MCTRL−NSET2 Speed setpoint on speed
controller input
(MCTRL_nNSetIn_a)
Read only
−100,00 {0.01 %} 100.00
C0051 MCTRL−NACT Actual speed (MCTRL_nNAct_a)
Read only
−30000 {1 rpm} 30000
C0052 MCTRL Umot Actual motor voltage
Read only
0 {1 V} 800